NASA Technical Reports Server (NTRS) 20160014608: Single-Event Latchup Testing Of The Micrel MIC4424 Dual Power MOSFET Driver - Info and Reading Options

The Internet Archive:

We conducted 47 exposures of four different MIC4424 devices and did not observe any SEL or high-current events. This included worst-case conditions with a LET of 81 MeV-sq cm/mg, applied voltage of 18.5 V, a case temperature greater than 120 C, and a final fluence of 1x10(exp 7)/sq cm. We also monitored both the outputs for the presence of SETs. While the period of the 1 MHz square wave was slightly altered in some cases, no pulses were added or deleted. 1. Purpose: The purpose of this testing is to characterize the BiCMOS/DMOS Micrel MIC4424 dual, non-inverting MOSFET driver for single-event latchup (SEL) susceptibility. These data will be used for flight lot evaluation purposes. 2. Devices Tested: The MIC4423/4424/4425 family are highly reliable BiCMOS/DMOS buffer/driver MOSFET drivers. They are higher output current versions of the MIC4426/4427/4428. They can survive up to 5V of noise spiking, of either polarity, on the ground pin. They can accept, without either damage or logic upset, up to half an amp of reverse current (either polarity) forced back into their outputs. Primarily intended for driving power MOSFETs, the MIC4423/4424/4425 drivers are suitable for driving other loads (capacitive, resistive, or inductive) which require low-impedance, high peak currents, and fast switching times. Heavily loaded clock lines, coaxial cables, or piezoelectric transducers are some examples. The only known limitation on loading is that total power dissipated in the driver must be kept within the maximum power dissipation limits of the package. Five (5) parts were provided for SEL testing. We prepared four parts for irradiation and reserved one piece as an un-irradiated control. More information about the devices can be found in Table 1. The parts were prepared for testing by removing the lid from the CDIP package to expose the target die. The parts were then soldered to small copper circuit adapter boards for easy handling. These parts are fabricated in a bulk BiCMOS/DMOS technology. Since we do not know the number of overlayers used in the fabrication processes, linear energy transfer calculations are determined based on the top-surface incident ion species and kinetic energy.

Search for “NASA Technical Reports Server (NTRS) 20160014608: Single-Event Latchup Testing Of The Micrel MIC4424 Dual Power MOSFET Driver” downloads:

Visit our Downloads Search page to see if downloads are available.

Find “NASA Technical Reports Server (NTRS) 20160014608: Single-Event Latchup Testing Of The Micrel MIC4424 Dual Power MOSFET Driver” in Libraries Near You:

Read or borrow “NASA Technical Reports Server (NTRS) 20160014608: Single-Event Latchup Testing Of The Micrel MIC4424 Dual Power MOSFET Driver” from your local library.

• The WorldCat Libraries Catalog: Find a copy of “NASA Technical Reports Server (NTRS) 20160014608: Single-Event Latchup Testing Of The Micrel MIC4424 Dual Power MOSFET Driver” at a library near you.