Downloads & Free Reading Options - Results

Theoretical analysis of an electrostatically driven wall system for a compliant wall drag reduction program is reported. The electrostatic wall system is capable of producing deflections of many orders greater than the thicknesses and at small wavelengths. An intermediate large response theory was used for structural analysis. The theoretical predictions were compared to bench test results, and good agreement between the two was obtained. The effects of aerodynamic loads and perturbation electric fields on the theoretical solutions were considered. It was shown that for very small wavelengths (approximately 2mm) the aerodynamic effects can be estimated using potential theory without loss of accuracy, and the perturbation electric fields do not affect solutions as long as the deflections are less than one percent of the wavelength. Resonance effects for this type of structure were shown to be fairly small.

Theoretical analysis of an electrostatically driven wall system for a compliant wall drag reduction program is reported. The electrostatic wall system is capable of producing deflections of many orders greater than the wall thicknesses and at small wavelengths. An intermediate large response theory is used for structural analysis. The theoretical predictions are compared to bench test results, and good agreement between the two is obtained. The effects of aerodynamic loads and perturbation electric fields on the theoretical solutions are considered. It is shown that for very small wavelengths (lambda almost equals 2 mm) the aerodynamic effects can be estimated using potential theory without loss of accuracy, and the perturbation electric fields do not effect solutions as long as the deflections are less than one percent of the wavelength. Resonance effects for this type of structure are shown to be fairly small.

Surface motion of compliant walls in drag reduction experiments was analyzed. The spectrum of surface motion indicates that membranes over deep cavities respond at low frequencies and large wavelengths. The membrane over a deep cavity is therefore found not to yield the desired reponse predicted by the postulated mechanism. The membrane over a thin air gap is found to act as a wavelength chopper, and analysis of the nonlinear response of the compliant surface indicates its possible suitability for compliant wall experiments. Periodic structures are found to lock in the desired wavelengths of motion. Laminated structures are found to be very ineffective as compliant models, except when there is no bonding between the membrane and the backing. Computer programs developed for these analyses are documented.

Surface motion of compliant walls in drag reduction experiments was analyzed. Critical comparison was made between the dynamic motion of the structure and the postulated mechanism of drag reduction. The spectrum of surface motion indicated that membranes over deep cavities respond at low frequencies and large wavelengths. The membrane over a deep cavity is therefore found not to yield the desired response predicted by the postulated mechanism. The membrane over a thin air gap is found to act as a wavelength chopper, and analysis of the nonlinear response of that compliant surface indicated its possible suitability for compliant wall experiments. Periodic structures are found to lock in the desired wavelengths of motion, and it was shown that at least in Kramer's initial experiments they produced high frequency surface motions. Laminated structures are found to be very ineffective as compliant models, except when there is no bonding between the membrane and the backing. Computer programs developed for these analyses are documented.

NAS 1.26:2999 Digitized from IA1177305-03-0042 , IA1177305-03-0043 .